Tools Needed:
- Drill
- 3.5mm-4mm Drill bit
- Riveter
Step 1: Drill rivets in the bottom cover (30 pieces with drill bit 3.5mm-4.0mm) Be careful with rivets marked in the picture below – the power supply is located underneath these.
Step 2: Drill rivets in back cover of the unit.
Step 3: Perform E-Brake Adjustment from Video
Step 4: Test to see if squeaking has been resolved. If not, keep adjusting the E-Brake until issue is resolved.
Step 5: Once Step 3 & 4 are done, Reattach panels with Riveter. Rivet sizes can be seen below (These will need to be purchased from a local store).
Step 6: You’re ready to start using your Motion Platform V3 again!
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article